Radial X-AMP Active Reamper

Active Reamper Module


»  View entire Radial Engineering range

The Radial X-Amp™ is a 500 Series module that lets you take a pre-recorded guitar track and send it back to amplifiers and effects so that you can tailor the sound to suit.

The advantages of Reamping™ are many: when recording, the guitarist need only concentrate on the performance. Working out specific sounds and optimal mic placement can be done later. This eliminates hours of tiresome repetition while allowing the producer to adjust the character of the track as the production evolves.

Download Full Brochure
  • Active Reamp® designed for 500 series racks
  • 100% discrete class-A electronics for best tone
  • Transformer isolated to eliminate hum and buzz
  • Easy access front panel jacks & controls

Using the Radial X-Amp is 'plug and play' easy to use. The design begins with an XLR balanced line level input located on the 500 series rear panel that feeds the X-Amp. To ensure the very highest fidelity, 100% Discrete Class-A circuitry is employed.

The X-Amp unbalances and buffers the pre-recorded signal where it then feeds two transformer isolated hi-Z guitar level outputs. The ¼" jacks are front mounted for desk-top convenience and equipped with ground lifts to help eliminate hum and buzz caused by ground loops. Independent level controls enable you to adjust the drive going to each amp for optimal tone. Should one of the amps be out of phase, depressing the 180º quickly brings both in line.

The X-Amp Reamper™ works with guitars, basses, keyboards and even voice! You can send the signal through guitar effects pedals too. In fact the only thing holding you back is your imagination.

The Radial X-Amp…active Reamping™ made easy.
 

Recording a dry track with the X-Amp
Plug your guitar into some pedals, send the signal to the JDX to take advantage of the advanced multistage filter. No amps or mics to set up. Instant gratification!

 

 

 

 

Reamping with the X-Amp
Send the prerecorded clean (dry) track to the X-Amp using the XLR input on your 500 series rack. Feed the signal from Out-1 and Out-2 to your guitar amps. Mic them and record!

 

 

 

 

Using the X-Amp as a distro
Connect your guitar to the Omniport on the Workhorse. The guitar signal can then be sent to two amplifiers using out-1 and out-2 up to 15 meters (50 feet) away.

Find your nearest dealer


Need help finding a dealer?

If you have difficulty in finding a dealer please contact us directly. We can help identify the most suitable dealer for your needs.

 

Find your nearest service agent


Need help finding support?

If you have difficulty in finding support, please contact us directly. We can help identify the most suitable agent for your needs.